Smazat příspěvek

 Chystáte se smazat zprávu (se všemi případnými odpověďmi) z kategorie Píseček:


10.04.2014 (13:59:50)
Janis B obalka (web) :
About 60V40A power supplyYou wrote "" The upper diode (D5) sees 20A average current in the worst case, for the lower diode (D6) it 40A. The upper diode thus can be selected for half current than the bottom one.""
I am deeply impressed by Your job, but here You miss the point, its straight contrary. The upper one is heavy duty diode and bottom is light.
Just try it into LTSpice or just measure, and You shall see it. Sure is worth to clear this mistake.
Yet anyway thanks for idea of such "strange" rectifier, its beautiful.
10.04.2014 (21:03:59)
Dr. Doktor:
Danyk is right. In the worst case the lower diode can conduct with near 100% duty cycle (with output short circuited), but the upper diode will not conduct with more than 50% duty cycle (limited by the IC and topology). The peak currents are the same.
11.04.2014 (00:14:50)
8-bit obalka (web) :
Janis is right, Doctor! During the forward pulse, all of the current flows trough the upper diode and an energy accumulates in both capacitor and series inductor. After that, when the power is cut off, energy stored in inductor's core creates a current flow trough the lower diode, which continues charging the capacitor. Value of this current is only a fraction of initial current (one half if an optimal series inductance is chosen). **37
11.04.2014 (00:26:45)
VroutekD obalka :
Ty by ses měl radši vrátit do školních lavic, protože plácáš naprostý sračky, stejně jako Janis.
Value of this current is only a fraction of initial current ten proud je v okamžiku přepnutí úplně stejnej , jen postupně klesá. Horní dioda vidí maximálně půlku výstupního proudu, dolní dioda vidí maximálně celý proud. Pokud to nejsi schopen pochopit ani teď, že je to dáno topologií toho měniče, tak už se radši ani neozývej.
A pokud nás chceš přesvědčit o své genialitě, tak nám nakresli obrázek obvodu s náčrtky časových průběhů proudů a napětí v tom výstupním obvodu. Můžeš taky dodat výpočet, ze kterého určíš tu tvojí indukčnost.
11.04.2014 (00:37:39)
VroutekD obalka :
Když už se v tom chcete hnípat, tak si radši překontrolujte zvlnění výstupní tlumivkou, je totiž blbě navržená.
11.04.2014 (01:10:06)
8-bit obalka (web) :
Tak za prvé je od začátku řeč o střední hodnotě;
a za druhé dám na tvou radu a už se nebudu ozývat, vůbec. Tady už nebudu ani minutu kvůli kritickému zamoření tvýma sračkama.

Tak sbohem, hoši.
11.04.2014 (01:20:26)
VroutekD obalka :
Ano, je řeč o střední hodnotě. Máš to dokonce psané i v původním danykově textu. Horní dioda vidí max. půlku proudu, co dolní. Takže nevím, co tu plácáš o nějakých zlomcích proudu indukčností, to nejsou žádný zlomky. Proud cyklicky roste a klesá, tyto nárůstky a poklesy jsou definovány jako tzv zvlnění (superponované na střední hodnotě odběru ze zdroje), které se musí navrhnout tak, aby jej ustály zejména výstupní kýbly, což zde splnění není. 27uH nestačí, to je málo.
Slovo Doktora ohledně impulsních zdrojů bys měl brát jako svaté. Pokud to nerespektuješ, tak ti není pomoci.
Zřejmě si za svou teorií moc nestojíš, jinak bys nás blbce poučil výstižným náčrtkem, jak to s tím zlomkem proudu cívkou myslíš.
11.04.2014 (20:09:27)
Dr. Doktor:
Ještě že 8-bit odešel, aspoň tu nebude ostatním blbě radit. Promiň, ale jestli se chceš hádat o tomhle, tak té výkonovce vůbec nerozumíš.
11.04.2014 (22:26:04)
Janis B obalka (web) :
Simply I made a computer simulation of this simple circuit. I know.....
11.04.2014 (22:58:53)
VroutekD obalka :
And what did the simulation say? That the current in both diodes is the same?
11.04.2014 (23:23:17)
danyk obalka (web) :
Hello. The lower diode really carries twice the current (in worst case) than the upper diode does (in worst case). This operates in CCM (continuous current mode). Thank to the inductour the current flows continuously. Imagine this: The output current is 40A and the voltage is very low. This means that duty cycle is very low. The upper diode is opened for very short times only (and carries almost no average current) and thus almost the entire 40A flows through the lower diode. When the duty cycle is maximum (50%), each of diodes is opened for 50% of cycle time and thus each of them carries 20A.


Přezdívka:*
Heslo:*

███   ███   ███   
  █   █       █   
 █    ███   ███   
 █      █     █   
 █    ███   ███   
Opiš:*

Zde můžete smazat vlastní vlákno nebo kteroukoliv odpověď v něm. Můžete smazat vlastní odpověď v cizím vlákně, pokud na ni ještě nikdo jiný nereagoval. Mazat cizí vlákna a odpovědi v nich mohou pouze admini. Smazání příspěvku je nevratná operace! Smazáním vzkazu se smažou i odpovědi na něj.
Seznam uživatelů
Zpět na knihu